The Internet's Lowest Prices on Pins and Badges

FREE Die Charges , B2 Promo offers this for orders over 1,000 pieces.

The Die or rubber mold is required to produce or stamp out your lapel pins. Each Die is hand carved into the steel for the Die Struck process and for a typical 1" lapel pin the die is usually 4" wide and at least 4 inches thick and weighs approximately 4 lbs. Die or Molds for the die casting process are made from rubber and are hand carved from wax a true art! As you can see the amount of time and artistry required for manufacturing lapel pins is truly astonishing!

Call 888.277.6662 for pricing.

B2 Promo
Spangler Road
Hermitage, Pennsylvania 16148

724-342-4545    Fax: 724.342.7808

Copyright © 2010 B2 Promo All rights reserved